![]() ![]() It if still isn't in the list then the driver is not loading for some reason like the radio is not on or connected or the driver has not been installed properly so that needs to be rectified before going on. If it isn't in the list then click the SerPort button to repopulate the list. Select the SilconLabs driver from the dropdown list. Now choose the Serial Port to use Mac/Linux PTT via CAT will normally be set by default, but you can verify by looking at the PTT-Generic page. Note: The RTS +12v and DTR +12v boxes do not normally need to be checked. That will select the default settings which will be good for starters. Go to the menuĬhoose the 7300 from the Rig dropdown list. It will come up with just a basic display. With the radio on and the USB cable connected and no other communications program running, Start For those choosing to use flrig continue below, otherwise scroll down to the Setup Fldigi section: Flrig control optionįirst, we get flrig going then it’s a piece of cake to get fldigi going with it. For Mac and Linux install them as you would any other application. Putting them in other folders can causes permissions issues sometimes on Windows 10. For Windows they install to their own folders and should be installed in the normal application directory where other apps are installed. Install fldigi and flrig (if you choose to use flrig). You should have already installed the driver for the built-in sound card in the 7300.Ĭonnect the rig to the computer with a USB A-Male to B-Male cable and turn on the radio. If choosing RigCat for rig control then set it On. Note: Echo Back set to On is optional now as far as Flrig is concerned, but if other software is interfacing with the 7300 it may require Echo On. Response will be a bit quicker with higher rates, but it will do well at 19,200 also. ![]() I use 115,200, but use 19,200 for starters as that is what fldigi/flrig defaults to. Many of these are ok at default, but verify the ones listed below: Once the above are set then touch the CI-V line on screen to get a list of items to set especially forĬAT control. See the fldigi manual on setting up the sound levels. Something to play with to make it work best for you. Too much and you overdrive fldigi and decoding suffers, too little and you may miss weak signals though fldigi does very well with very weak signals. This is the built-in soundcard in the radio output level that goes into fldigi on receive. ACC/USB AF Output level - I have mine set at 40% if I have the AGC set to Fast which is default.How to fine tune it will be explained later. This is the input level control for the TX sound from the computer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |